.

If you are getting a battery saver active message, it means that your Malibus electrical system voltage has dropped to a critical level (less than 11.

The battery should also be over 12 volts even with the vehicle sitting. Second, check for continuity between the terminal and the body of the solenoid.

(Formerly) FireRanger.

This will place a parasitic drain on the battery, which will eventually cause it to go dead.

Rinse and repeat. I think you will only see a box if you have power windowslocks for the extra relays. The alternator is responsible for keeping the battery charged, and it is the most common reason why the Battery Saver Active message comes up.

Second time.

0. Apr 22, 2020 2nd test. The relay is in the same little box under the dash as the signal flashers.

First truck -- 1929 Model A Ford pickup, restored from ground up. Battery saver mode (transport mode) is initiated by turning on the hazard flashers and then turning the ignition key into the crank position or pushing the push button start switch.

&183; 4 &183; Oct 26, 2009.

The average relay replacement cost is between 15 and 80, depending on the model and labor costs.

The alternator is responsible for keeping the battery charged, and it is the most common reason why the Battery Saver Active message comes up. While running at all rpms and with electrical loads on and off, is the battery maintaining 13-15 volts You want a excellent 5 star answer & I would like to be rated the same for providing it.

. .

N000000004039 A000000004039 12V 1.
.

7 volts).

. . The draining circuit was FUSE 14, 15A, "Battery Saver Relay, Interior Lamp Relay".

(Formerly) FireRanger. Nov 22, 2014 klhansen. Since bad relays can kill FICM, it is a good idea to just replace it every 100k for good measure. If your truck is running fine when you park it, and it wont start, there is an issue with the charging system (alternator, battery, or battery cables) or a parasitic power draw. February 20, 2022.

.

they said that the battery went from 40 to 85 and they thought they fixed it. The battery saver relay is controlled by the (GEM) generic electronic module , fords version of a BCM - body control module , if you know what that is.

Car Wont Start 2.

The function of the battery saver relay is to prevent excessive battery drain by interior lighting circuits.

There are 4 or 5 relaysflashers in it.

If they relay short circuits, it can drain the computer battery, even when the vehicle is off.

.